Switching on – Festo Электромотор MTR-DCI User Manual
Page 83
5. Commissioning
5-5
Festo P.BE-MTR-DCI-IO-EN en 1209d
Switching on
Note
Note that the tolerance for the supply voltage must be
observed. The tolerance must also be observed directly
at the operating voltage connection of the MTR-DCI
(see chapter 3.3).
Note
•
Make sure that the axis is within the permitted position-
ing range when it is switched on. Instructions on this can
be found in chapter 1.5.1.
•
When the power supply is switched off, wait for approx.
5 seconds before switching the device on again.
•
Switch on the power supply for the MTR-DCI.
When the power supply is switched on, the MTR-DCI
automatically carries out an internal check.
•
Carry out parametrizing and commissioning with the
control panel or the FCT, as described in the following
chapters or in the FCT/PlugIn help.
•
In order to complete commissioning note the instructions
for operation in the FCT/PlugIn help and in chapter 6.1.