Festo Электромотор MTR-DCI - Manual (Page 61)

4. Control panel (MTR-DCI-...-H2IO)
4-3
Festo P.BE-MTR-DCI-IO-EN en 1209d
On the control panel, motor unit type MTR-DCI-...- H2 offers all
the functions necessary for commissioning, programming and
diagnosis. An overview of the button and menu functions for
the MTR-DCI-...IO can be found in this chapter. Commission-
ing with the control panel is described as from chapter 5.2.
With the MTR-DCI-...-
R2 (without control panel) you can com-
mission the MTR-DCI via the RS232 interface (with FCT soft-
ware). Instructions on this can be found in chapter 5.3.
Caution
Faults may occur if you attempt to access control and
operating functions at the same time via the FCT and the
control panel.
• Make sure that the FCT, the control panel and the control
interface of the MTR-DCI are not used at the same time.
Note
If necessary, remove the protective foil from the display
before commissioning.