Festo Электромотор MTR-DCI - Manual (Page 68)

4. Control panel (MTR-DCI-...-H2IO)
4-10
Festo P.BE-MTR-DCI-IO-EN en 1209d
[System param] Menu command for displaying the following system para-
meters and data:
[System param] Description
V power [V] Supply voltage
V dd [V] Voltage of display
I max [A] Maximum current
I act [A] Current current
Temp [°C] Operating temperature
Cycle Number of positioning movements
In signal Hexadecimal representation of the inputs
Bit 0: I0
Bit 1: I1
Bit 2: I2
Bit 3: I3
Bit 4: START
Bit 5: ENABLE
Out signal Hexadecimal representation of the outputs
Bit 0: READY
Bit 1: MOTION COMPLETE
Ref. switch on/off Signal at reference switch input
Mode e.g. mm Measuring system
Hom.meth. – bl.pos
– bl.neg
– sw.pos
– sw.neg Fixed stop in positive direction
Fixed stop in negative direction
Reference switch in positive direction
Reference switch in negative direction
Gear e.g. 6.75 Gear ratio of the MTR-DCI