Festo Электромотор MTR-DCI - Manual (Page 97)

5. Commissioning
5-19
Festo P.BE-MTR-DCI-IO-EN en 1209d
5.3 Commissioning with FCT
5.3.1 Installing the FCT
Note
The PlugIn MTR-DCI version V1.1.0 supports the following
motor units of MTR-DCI-...IO:
– MTR-DCI-32: Firmware version V-DME 1.20
– MTR-DCI-42: Firmware version V-DME 1.19 / 1.20
– MTR-DCI-52: Firmware version V-DME 1.19 / 1.20
– MTR-DCI-62: Firmware version V-DME 1.20
• Check with later versions of the MTR-DCI to ascertain
whether an updated PlugIn is provided. If necessary
consult Festo.
Note
Administrator rights are required for installing the FCT.
The FCT is installed on your PC with an installation program.
The PlugIn MTR-DCI is installed on your PC together with the
installation program of the FCT.
1. Close all programs.
2. Place the Festo Configuration Tool CD in your CD ROM
drive. If Auto Run is activated on your system, installation
will start automatically and you can omit steps 3 and 4.
3. Select [Execute] in the starting menu.
4. Enter D:\setup (if necessary replace D by the letter of your
CD ROM drive).
5. Follow the instructions on the display screen.