Festo Электромотор MTR-DCI - Manual (Page 66)

} Diagnostic
}
Pos.set table
Axis param
System param
SW information
4. Control panel (MTR-DCI-...-H2IO)
4-8
Festo P.BE-MTR-DCI-IO-EN en 1209d
For selecting the menu commands [Positioning] and [Settings]
you will require the setting “HMI: on”. Only then is the
MTR-DCI ready to process user entries on the control panel.
When selecting the menu commands, you will be requested
to modify the HMI setting.
You can also modify the setting directly in the main menu
with the menu command [HMI control].
4.2.2 Menu [Diagnostic]
In order to display the system data and the currently effective
settings:
1. Select [Diagnostic] in the main menu with the arrow
buttons and press the <Enter> button.
2. Select one of the following menu commands:
– Position set table [Pos. set table]
– Axis parameter [Axis param]
– System parameter [System param]
– Version of firmware of the MTR-DCI [SW information]
Function Button
<- -> You can “scroll through” the
diagnostic data with the arrow
buttons.
v V
ESC With <Menu> you can return to the
higher-order menu level.
Menu