Festo Электромотор MTR-DCI User Manual
Page 158
B. Supplementary information
B-22
Festo P.BE-MTR-DCI-IO-EN en 1209d
Data_Memory_Control
CI access
20F1h
01h...02h
Array
uint8
w
Description
Commands for the EEPROM (non-volatile data storage)
Delete EEPROM 20F1h
01h
uint8
w
When the Object is written and after Power Off/On the data in EEPROM is
deleted.
Fix: 16 (0x10): Create factory settings (delete data in EEPROM)
Save Data 20F1h
02h
uint8
w
The data in the EEPROM will be overwritten with the current user-specific
settings.
Fix 1 (0x01): Save data
Note
All user-specific settings will be lost if deleted (except for
cycle number). The status after deletion corresponds to
the standard factory setting.
•
Always carry out a first commissioning after deleting the
EEPROM.
•
The settings of the LCD parameters are lost when the
EEPROM is deleted and must be carried out again. With
an unfavourable parameter setting the LCD remains
black.
•
In case of problems: consult the Festo Service.
Note on firmware V1.19
When the EEPROM is deleted the gear factor will be set to
the standard factory setting (= 6.75).
•
To set the gear factor: consult the Festo Service.