Festo Электромотор MTR-DCI - Manual (Page 24)

1. System summary
1-6
Festo P.BE-MTR-DCI-IO-EN en 1209d
1.2 Components
For setting up an electric drive with the MTR-DCI you will
require the following components:
Motor unit MTR-DCI Motor with controller, available in four sizes, optionally with
control panel (type ...-H2).
By means of different gear reductions, different require-
ments can be fulfilled in respect of (gear unit) output torque
and (gear unit) output speed (see appendix A.1). High drive
output torques with low drive output speeds are character-
istic for positioning functions. With the smaller gear reduc-
tion, the positioning speed of the axis can be increased with
correspondingly reduced positioning force.
Axis Linear or rotation axes as per catalogue
Coupling with coupling
housing For the axial attachment of Festo axes, e.g. type DMES-... or
type DNCE-..., couplings and coupling housings are avail-
able as accessories. The motor unit is connected to the axis
by means of a clamping connection in the coupling housing.
Additional motor flanges are not therefore necessary. Fur-
ther information can be found in the operating instructions
for the axis.
Power supply cable for supplying the MTR-DCI with operating voltage via a
power unit (DC 24 V / size 62: 48 V)
Programming cable Parametrizing the MTR-DCI during commissioning with the
FCT
Homing Switch Sensor as per appendix A.2.
Accessories For positioning systems Festo offers special matching ac-
cessories (see Festo delivery program or catalogue).