Festo Электромотор MTR-DCI - Manual (Page 99)

5. Commissioning
5-21
Festo P.BE-MTR-DCI-IO-EN en 1209d
Instructions on parametrizing and commissioning
Further information can be found in the help for the FCT with
the command [Help] [Contents FCT general] e.g.
– Help on working with projects and on inserting a device
into a project.
– Help on defining the measuring reference system
(referencing and basis coordinates).
The PlugIn MTR-DCI for the FCT supports all the steps necess-
ary for commissioning an MTR-DCI.
With the PlugIn MTR-DCI for the FCT the necessary paramet-
rizing can be carried out offline, i.e. without the MTR-DCI
being connected to the PC. This enables the actual commis-
sioning to be prepared, e.g. in the design office when a new
system is being planned.
Further information can be found in the PlugIn help:
Command [Help] [Contents of installed PlugIns] [Festo
(manufacturer name)] [MTR-DCI (PlugIn name)] e.g.:
– for describing the dialogues of the “Device MTR-DCI”
– for describing the work steps for commissioning
– for the basic functions: Device connection, Device names,
Device control and for password protection.