Yaskawa J1000 Compact Vector Control Drive - Manual (Page 216)

Table C.4 Three-Phase 400 V Class Fuses and Fuse Holders
Drive Model
DC Power Supply Input
Fuse Fuse Holder
Manufacturer: Fuji Electric
Type
Rated Short
Circuit Braking
Current (kA)
Qty. Type Qty.
4A0001 CR6L-20/UL
100 2
CMS-4
2
4A0002 CR6L-20/UL CMS-4
4A0004 CR6L-50/UL CMS-4
4A0005 CR6L-50/UL CMS-4
4A0007 CR6L-50/UL CMS-4
4A0009 CR6L-50/UL CMS-4
4A0011 CR6L-50/UL CMS-4
4A0018 CR6L-50/UL CMS-4
4A0023 CR6L-75/UL CMS–5
4A0031 CR6L-100/UL CMS–5
4A0038 CR6L-150/UL CMS–5
n Guarding Against Harmful Materials
When installing IP20/Open-Chassis enclosure drives, use an enclosure that prevents foreign
material from entering the drive from above or below.
u EMC Guidelines Compliance
This drive is tested according to European standards EN 61800-3:2004/A1:2012 and it
complies with the EMC guidelines.
n EMC Filter Installation
The following conditions must be met to ensure continued compliance with guidelines. Refer
to EMC Filters on page 219 for EMC filter selection.
Installation Method
Verify the following installation conditions to ensure that other devices and machinery used
in combination with this drive also comply with EMC guidelines.
1.
Install an EMC noise filter to the input side specified by Yaskawa for compliance with
European standards.
2.
Place the drive and EMC noise filter in the same enclosure.
3.
Use braided shield cable for the drive and motor wiring or run the wiring through a
metal conduit.
C.1 European Standards
216 YASKAWA ELECTRIC TOEP C710606 47C YASKAWA AC Drive – V1000 Quick Start Guide