PLANET WGSW-52040 - Manual (Page 113)

compare the priority of the systems, if they are same, then compare the MAC address of the
systems. The end with a small device ID has the high priority.
Compare the ID of the ports (the priority of the port + the ID of the port). For each port in the
side of the device which has the high device priority, first, compare the priority of the ports, if
the priorities are same, then compare the ID of the ports. The port with a small port ID is
selected, and the others become the standby ports.
In an aggregation group, the port which has the smallest port ID and is at the selected state will
be the master port, the other ports at the selected state will be the member port.
12.2.3 Port Channel Configuration Task List
1. Create a port group in Global Mode
2. Add ports to the specified group from the Port Mode of respective ports
3. Enter port-channel configuration mode
4. Set load-balance method for port-group
5. Set the system priority of LACP protocol
6. Set the port priority of the current port in LACP protocol
7. Set the timeout mode of the current port in LACP protocol
1. Creating a port group
Command Explanation
Global Mode
port-group <port-group-number>
no port-group <port-group-number>
Create or delete a port group.
2. Add physical ports to the port group
Command Explanation
Port Mode
port-group <port-group-number> mode
{active | passive | on}
no port-group
Add the ports to the port group and set their
mode.
12-35