PLANET WGSW-52040 - Manual (Page 86)

Chapter 7 Port Configuration
7.1 Introduction to Port
Switch contains Cable ports and Combo ports. The Combo ports can be configured to as
either 1000GX-TX ports or SFP Gigabit fiber ports.
If the user needs to configure some network ports, he/she can use the interface ethernet
<interface-list> command to enter the appropriate Ethernet port configuration mode, where
<interface-list> stands for one or more ports. If <interface-list> contains multiple ports, special
characters such as ';' or '-' can be used to separate ports, ';' is used for discrete port numbers
and '-' is used for consecutive port numbers. Suppose an operation should be performed on
ports 2,3,4,5 the command would look like: interface ethernet 1/2-5. Port speed, duplex mode
and traffic control can be configured under Ethernet Port Mode causing the performance of the
corresponding network ports to change accordingly.
7.2 Network Port Configuration Task List
1. Enter the network port configuration mode
2. Configure the properties for the network ports
(1) Configure combo mode for combo ports
(2) Enable/Disable ports
(3) Configure port names
(4) Configure port cable types
(5) Configure port speed and duplex mode
(6) Configure bandwidth control
(7) Configure traffic control
(8) Enable/Disable port loopback function
(9) Configure broadcast storm control function for the switch
(10) Configure scan port mode
(11) Configure rate-violation control of the port
(12) Configure interval of port-rate-statistics
3. Virtual cable test
7-8