PLANET WGSW-52040 - Manual (Page 381)

4. Configure the violation mode of ports
5. Display and debug the relative information of number limitation of MAC and IP on ports
1. Enable the number limitation function of MAC and IP on ports
Command Explanation
Port configuration mode
switchport mac-address dynamic
maximum <value>
no switchport mac-address dynamic
maximum
Enable and disable the number limitation
function of MAC on the ports.
switchport arp dynamic maximum <value>
no switchport arp dynamic maximum
Enable and disable the number limitation
function of ARP on the ports.
switchport nd dynamic maximum <value>
no switchport nd dynamic maximum
Enable and disable the number limitation
function of ND on the ports.
2. Enable the number limitation function of MAC and IP in VLAN
Command Explanation
VLAN configuration mode
vlan mac-address dynamic maximum
<value>
no vlan mac-address dynamic maximum
Enable and disable the number limitation
function of MAC in the VLAN.
Interface configuration mode
ip arp dynamic maximum <value>
no ip arp dynamic maximum
Enable and disable the number limitation
function of ARP in the VLAN.
ipv6 nd dynamic maximum <value>
no ipv6 nd dynamic maximum
Enable and disable the number limitation
function of NEIGHBOR in the VLAN.
3. Configure the timeout value of querying dynamic MAC
Command Explanation
Global configuration mode
mac-address query timeout <seconds>
Configure the timeout value of querying
dynamic MAC.
4. Configure the violation mode of ports
43-160