PLANET WGSW-52040 - Manual (Page 329)

SwitchB#config
SwitchB(config)#ipv6 mld snooping
SwitchB(config)#ipv6 mld snooping vlan 100
SwitchB(config)#ipv6 mld snooping vlan 100 mrouter interface ethernet 1/1
Multicast configuration:
Same as scenario 1
MLD Snooping interception results:
Same as scenario 1
39.1.4 MLD Snooping Troubleshooting
In configuring and using MLD Snooping, the MLD Snooping server may fail to run properly due
to physical connection failure, wrong configuration, etc. The user should ensure the following:
 Ensure the physical connection is correct
 Ensure the MLD Snooping is enabled under global mode (using ipv6 mld snooping)
 Ensure the MLD Snooping is configured on the vlan under global mode (using ipv6
mld snooping vlan <vlan-id>）
 Ensure there is a vlan configured as a L2 general querier, or there is a static mrouter
configured in a segment,
 Use command to check if the MLD snooping information is correct
39-108