PLANET WGSW-52040 - Manual (Page 42)

Input the right username and password, and then the main Web configuration interface is shown as below.
Figure 3-11 Main Web Configuration Interface
When configure the switch, the name of the switch is composed with English letters.
3.1.2.3 Manage the Switch via SNMP Network Management Software
The necessities required by SNMP network management software to manage switches:
1) IP addresses are configured on the switch;
2) The IP address of the client host and that of the VLAN interface on the switch it subordinates to
should be in the same segment;
3) If 2) is not met, the client should be able to reach an IP address of the switch through devices like
routers;
4) SNMP should be enabled.
The host with SNMP network management software should be able to ping the IP address of the switch, so
that, when running, SNMP network management software will be able to find it and implement read/write
operation on it. Details about how to manage switches via SNMP network management software will not be
covered in this manual, please refer to “Snmp network management software user manual”.
3-18