PLANET WGSW-52040 - Manual (Page 191)

switchport port-security lock
no switchport port-security lock
Lock the port, then MAC addresses
learned will be disabled. The “no
switchport port-security lock” command
restores the function. Notice: This
command is not supported by the switch.
switchport port-security convert
Convert dynamic secure MAC addresses
learned by the port to static secure MAC
addresses. Notice: This command is not
supported by the switch.
switchport port-security timeout <value>
no switchport port-security timeout
Enable port locking timer function; the “no
switchport port-security timeout”
restores the default setting. Notice: This
command is not supported by the switch.
switchport port-security mac-address
<mac-address>
no switchport port-security
mac-address <mac-address>
Add static secure MAC address; the “no
switchport port-security mac-address”
command deletes static secure MAC
address.
Admin Mode
clear port-security dynamic [address
<mac-addr> | interface <interface-id>]
Clear dynamic MAC addresses learned by
the specified port.
3. MAC address binding property configuration
Command Explanation
Port Mode
switchport port-security maximum
<value>
no switchport port-security maximum
<value>
Set the maximum number of secure MAC
addresses for a port; the “no switchport
port-security maximum” command
restores the default value.
switchport port-security violation
{protect | shutdown} [recovery
<30-3600>]
no switchport port-security violation
Set the violation mode for the port; the “no
switchport port-security violation”
command restores the default setting.
21.5.1.3 Binding MAC Address Binding Troubleshooting
Enabling MAC address binding for ports may fail in some occasions. Here are some possible
causes and solutions:
21-113