PLANET WGSW-52040 - Manual (Page 169)

Multi-to-One VLAN translation configuration task list:
1. Configure Multi-to-One VLAN translation on the port
2. Show the related configuration of Multi-to-One VLAN translation
1. Configure Multi-to-One VLAN translation on the port
Command Explanation
Port mode
vlan-translation n-to-1 <WORD> to
<new-vlan-id>
no vlan-translation n-to-1 <WORD>
Configure/delete Multi-to-One VLAN
translation.
2. Show the related configuration of Multi-to-One VLAN translation
Command Explanation
Admin mode
show vlan-translation n-to-1
Show the related configuration of
Multi-to-One VLAN translation.
20.5.3 Typical application of Multi-to-One VLAN
Translation
Scenario:
UserA, userB and userC belong to VLAN1, VLAN2, VLAN3 respectively. Before entering the
network layer, data traffic of userA, userB and userC is translated into VLAN 100 by
Ethernet1/1 of edge switch1. Contrarily, data traffic of userA, userB and userC will be
translated into VLAN1, VLAN2, VLAN3 by Ethernet1/1 of edge switch1 from network layer
respectively. In the same way, it implements multi-to-one translation for userD, userE and
userF on Ethernet1/1 of edge switch2.
20-91