PLANET WGSW-52040 - Manual (Page 45)

 VLAN Mode
Using the vlan <vlan-id> command under Global Mode can enter the corresponding VLAN Mode. Under
VLAN Mode the user can configure all member ports of the corresponding VLAN. Run the exit command
to exit the VLAN Mode to Global Mode.
 DHCP Address Pool Mode
Type the ip dhcp pool <name> command under Global Mode will enter the DHCP Address Pool Mode
prompt “Switch(Config-<name>-dhcp)#”. DHCP address pool properties can be configured under DHCP
Address Pool Mode. Run the exit command to exit the DHCP Address Pool Mode to Global Mode.
 ACL Mode
ACL type Entry Operates Exit
Standard IP ACL
Mode Type ip access-list
standard command under
Global Mode. Configure parameters
for Standard IP ACL
Mode. Use the exit
command to return
to Global Mode.
Extended IP ACL
Mode Type ip access-list
extanded command under
Global Mode. Configure parameters
for Extended IP ACL
Mode. Use the exit
command to return
to Global Mode.
3.2.2 Configuration Syntax
Switch provides various configuration commands. Although all the commands are different, they all abide by
the syntax for Switch configuration commands. The general commands format of Switch is shown below:
cmdtxt <variable> {enum1 | … | enumN } [option1 | … | optionN]
Conventions: cmdtxt in bold font indicates a command keyword; <variable> indicates a variable parameter;
{enum1 | … | enumN } indicates a mandatory parameter that should be selected from the parameter set
enum1~enumN; and the square bracket ([ ]) in [option1 | … | optionN] indicate an optional parameter. There
may be combinations of “< >“, “{ }” and “[ ]” in the command line, such as [<variable>], {enum1 <variable>|
enum2}, [option1 [option2]], etc.
Here are examples for some actual configuration commands:
 show version, no parameters required. This is a command with only a keyword and no parameter, just
type in the command to run.
 vlan <vlan-id>, parameter values are required after the keyword.
 firewall {enable | disable}, user can enter firewall enable or firewall disable for this command.
 snmp-server community {ro | rw} <string>, the followings are possible:
snmp-server community ro <string>
snmp-server community rw <string>
3-21