PLANET WGSW-52040 - Manual (Page 382)

Command Explanation
Port mode
switchport mac-address violation {protect
| shutdown} [recovery <5-3600>]
no switchport mac-address violation
Set the violation mode of the port, the no
command restores the violation mode to
protect.
5. Display and debug the relative information of number limitation of MAC and IP on
ports
Command Explanation
Admin mode
show mac-address dynamic count {vlan
<vlan-id> | interface ethernet
<portName> }
Display the number of dynamic MAC in
corresponding ports and VLAN.
show arp-dynamic count {vlan
<vlan-id> | interface ethernet
<portName> }
Display the number of dynamic ARP in
corresponding ports and VLAN.
show nd-dynamic count {vlan
<vlan-id> | interface ethernet
<portName> }
Display the number of dynamic
NEIGHBOUR in corresponding ports and
VLAN.
debug switchport mac count
no debug switchport mac count
All kinds of debug information when
limiting the number of MAC on ports.
debug switchport arp count
no debug switchport arp count
All kinds of debug information when
limiting the number of ARP on ports.
debug switchport nd count
no debug switchport nd count
All kinds of debug information when
limiting the number of NEIGHBOUR on
ports.
debug vlan mac count
no debug vlan mac count
All kinds of debug information when
limiting the number of MAC in VLAN.
debug ip arp count
no debug ip arp count
All kinds of debug information when
limiting the number of ARP in VLAN.
debug ipv6 nd count
no debug ipv6 nd count
All kinds of debug information when
limiting the number of MAC in VLAN.
43-161