PLANET WGSW-52040 - Manual (Page 387)

Command Explanation
Global Configuration Mode
show am [interface <interface-name>]
Display the AM configuration information
of one port or all ports.
44.3 AM Function Example
………
SWITCH
Port2 Port1
Internet
HUB2 HUB1
PC1 PC2 PC30
Figure 44-1: a typical configuration example of AM function
h will only forward data packets from legal users while
ccording to the requirements mentioned above, the switch can be configured as follows:
witch(Config-If-Ethernet 1/1)#am ip-pool 10.10.10.1 10
In the topology above, 30 PCs, after converged by HUB1, connect with interface1 on the
switch. The IP addresses of these 30 PCs range from 100.10.10.1 to 100.10.10.30.
Considering security, the system manager will only take user with an IP address within that
range as legal ones. And the switc
dumping packets from other users.
A
Switch(config)#am enable
Switch(config)#interface ethernet1/1
Switch(Config-If-Ethernet 1/1)#am port
S
44-166