PLANET WGSW-52040 - Manual (Page 133)

low-warn} {<value> | default}}
3. Configure the state of the transceiver monitoring
(1) Configure the interval of the transceiver monitoring
Command Explanation
Global mode
transceiver-monitoring interval <minutes>
no transceiver-monitoring interval
Set the interval of the transceiver
monitor. The no command sets the
interval to be the default interval of
15 minutes.
（ 2）Configure the enable state of the transceiver monitoring
Command Explanation
Port mode
transceiver-monitoring {enable | disable}
Set whether the transceiver
monitoring is enabled. Only the port
enables the transceiver monitoring,
the system records the abnormity
state. After the port disables the
function, the abnormity information
will be clear.
（ 3）Show the information of the transceiver monitoring
Command Explanation
Admin mode and global mode
show transceiver threshold-violation
[interface ethernet <interface-list>]
Show the information of the
transceiver monitoring, including the
last threshold-violation informatijon,
the interval of the current transceiver
monitoring and whether the port
enables the transceiver monitoring.
16-55