PLANET WGSW-52040 - Manual (Page 319)

IFNAME limit group source strategy limitation”.
ip igmp snooping vlan <vlan-id>
l2-general-querier
no ip igmp snooping vlan <vlan-id>
l2-general-querier
Set this vlan to layer 2 general querier. It is
recommended to configure a layer 2 general
querier on a segment. The “no ip igmp
snooping vlan <vlan-id>
l2-general-querier”command cancels this
configuration.
ip igmp snooping vlan <vlan-id>
l2-general-querier-version <version>
Configure the version number of a general
query from a layer 2 general querier.
ip igmp snooping vlan <vlan-id>
l2-general-querier-source <source>
Configure the source address of a general
query from a layer 2 general querier.
ip igmp snooping vlan <vlan-id>
mrouter-port interface <interface –name>
no ip igmp snooping vlan <vlan-id>
mrouter-port interface <interface –name>
Configure static mrouter port of vlan. The no
form of the command cancels this
configuration.
ip igmp snooping vlan <vlan-id>
mrouter-port learnpim
no ip igmp snooping vlan <vlan-id>
mrouter-port learnpim
Enable the function that the specified VLAN
learns mrouter-port (according to pim
packets), the no command will disable the
function.
ip igmp snooping vlan <vlan-id> mrpt
<value >
no ip igmp snooping vlan <vlan-id> mrpt
Configure this survive time of mrouter port.
The “no ip igmp snooping vlan <vlan-id>
mrpt” command restores the default value.
ip igmp snooping vlan <vlan-id>
query-interval <value>
no ip igmp snooping vlan <vlan-id>
query-interval
Configure this query interval. The “no ip igmp
snooping vlan <vlan-id> query-interval”
command restores the default value.
ip igmp snooping vlan <vlan-id>
immediately-leave
no ip igmp snooping vlan <vlan-id>
immediately-leave
Enable the IGMP fast leave function for the
specified VLAN: the “no ip igmp snooping
vlan <vlan-id> immediate-leave” command
disables the IGMP fast leave function.
ip igmp snooping vlan <vlan-id>
query-mrsp <value>
no ip igmp snooping vlan <vlan-id>
query-mrsp
Configure the maximum query response
period. The “no ip igmp snooping vlan
<vlan-id> query-mrsp” command restores to
the default value.
38-98