PLANET WGSW-52040 - Manual (Page 271)

Switch3(Config-if-Vlan10)#exit
Switch3(config)#
Switch2 configuration：
Switch2>enable
Switch2#config
Switch2(config)#service dhcpv6
Switch2(config)#interface vlan 1
Switch2(Config-if-Vlan1)#ipv6 address 2001:da8:1:1::2/64
Switch2(Config-if-Vlan1)#exit
Switch2(config)#interface vlan 10
Switch2(Config-if-Vlan10)#ipv6 address 2001:da8:10:1::2/64
Switch2(Config-if-Vlan10)#exit
Switch2(config)#interface vlan 100
Switch2(Config-if-Vlan100)#ipv6 address 2001:da8:100:1::1/64
Switch2(Config-if-Vlan100)#no ipv6 nd suppress-ra
Switch2(Config-if-Vlan100)#ipv6 nd managed-config-flag
Switch2(Config-if-Vlan100)#ipv6 nd other-config-flag
Switch2(Config-if-Vlan100)#exit
Switch2(config)#
Switch1 configuration:
Switch1(config)#service dhcpv6
Switch2(config)#interface vlan 1
Switch2(Config-if-Vlan1)#ipv6 address 2001:da8:100:1::2/64
Switch2(Config-if-Vlan1)#ipv6 dhcp relay destination 2001:da8:10:1::1
32.7 DHCPv6 Troubleshooting
If the DHCPv6 clients cannot obtain IPv6 addresses and other network parameters, the
following procedures can be followed when DHCPv6 client hardware and cables have been
verified ok:
 Verify the DHCPv6 server is running, start the related DHCP v6 server function if not
running;
 If the DHCPv6 clients and servers are not in the same physical network, verify the
32-50