PLANET WGSW-52040 - Manual (Page 237)

Switch#config
Next hop use the partner IP address
Switch(config)#ip route 10.1.1.0 255.255.255.0 10.1.2.1
Next hop use the partner IP address
Switch(config)#ip route 10.1.4.0 255.255.255.0 10.1.3.1
Configuration of layer3 SwitchB
Switch#config
Switch(config)#ip route 0.0.0.0 0.0.0.0 10.1.3.2
In this way, ping connectivity can be established between PC-A and PC-C, and PC-B and
PC-C.
26.4 ARP
26.4.1 Introduction to ARP
ARP (Address Resolution Protocol) is mainly used to resolve IP address to Ethernet MAC
address. Switch supports static ARP configuration.
26.4.2 ARP Configuration Task List
ARP Configuration Task List:
1. Configure static ARP
1. Configure static ARP
Command Explanation
Interface Configuration Mode
arp <ip_address> <mac_address>
no arp <ip_address>
Configures a static ARP entry; the no
command deletes a static ARP entry.
26-16