Meridian America Link/Customer Controlled Routing - Manual (Page 106)

88 Chapter 5: Hardware installation overview
553-3202-210 Standard October 1998
Installing an IPE Module or an Application Module
This section summarizes the steps required to install an IPEÊModule and an
Application Module.
It is important to follow the list of procedures in the order in which they
appear below. When you have completed each procedure, return to this list
for the next procedure.
Table 11
Installing an IPE Module
Procedure Reference
1. Go through Chapter 6, ÒSite survey/installation checklist.Ó Page 91
2. Go through Chapter 7, ÒUnpack and inspect hardware.Ó Page 115
3. Install an SDI/DCH, ESDI, or MSDL card (if required).
See Chapter 8, ÒHardware installation procedures.Ó Page 142 (SDI/DCH)
Page 145 (ESDI or MSDL)
4. Install the IPE Module. See Chapter 8, ÒHardware
installation procedures.Ó Page 119
5. Cable to external equipment. See Chapter 9, ÒMeridian
Link/CCR interface cabling.Ó Page 177 (Option 11)
Page 209 (Options 21Ð81)
6. Install the peripheral devices. See Chapter 10, ÒInstalling
peripheral devices.Ó Page 261
7. Configure the Meridian 1. See Chapter 12, ÒMeridian 1
configuration for Meridian Link/CCR.Ó Page 293
8. Configure the links. See Chapter 15, ÒLink configuration.Ó Page 479
9. Install the base operating system and the applications. See
Chapter 14, ÒSoftware installation, upgrade, and update
procedures.Ó Page 371
10. Configure the applications. See Chapter 16, ÒAdditional
application configuration.Ó
Page 503