Meridian America Link/Customer Controlled Routing - Manual (Page 280)

262 Chapter 10: Installing peripheral devices
553-3202-210 Standard October 1998
The setup procedure is the same for all three terminals and is as follows:
1 Turn on the terminal.
2 Press the [Set-Up] key to enter setup mode.
The current setup values are displayed on a series of screens.
3 Using the following procedures, change the values on each screen
to match the values in the appropriate table.
To move to a particular screen from the main setup screen, use the
arrow keys to move through the menu of setup screens, and press
[Enter].
To move to the next setup screen, use the arrow keys to move to
To Next SetUp and press [Enter].
To change the value in a field:
¥ Use the arrow keys to move to that field.
¥ Press [Enter] to move through the available values for that field.
4 When youÕve finished, press the [Set-Up] key again.
Note: Different versions of the VT220, VT320, and VT420 are
indicated by the version number at the top right corner of the setup
screen. The wording on the setup screens varies slightly from one
version to another. Use the values that are closest to the ones shown
in the tables.