Meridian America Link/Customer Controlled Routing - Manual (Page 323)

Chapter 12: Meridian 1 configuration for Meridian Link/CCR 305
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Configure ESDI or MSDL port (X11 Release 18 or later)
The IPE Module or the Application Module is connected to the Meridian 1
through a port on a QPC513 ESDI card (vintage G or later), NTAK02
SDI/DCH card (Option 11, IPE Module only), or NT6D80 MSDL card.
The port must have the Application Module Link (AML) identified
(VSID 0Ð15). Define the port and its characteristics by responding to the
following prompts in LD 17.
Option 11 ESDI configuration
Table 108
LD 17ÑConfigure ESDI port (Option 11)
Prompt Response Comment
REQ CHG Create or change information in the
database
TYPE CFN Configuration record data block
ADAN NEW AML x Add AML on port x (VASID 0Ð15)
CDNO 0Ð15 Serial Data Interface Card Number
PORT 0Ð3 Port number on SDI/DCH card
DES LINK/CCR AML port designation (such as
ÒMeridian LinkÓ)
BPS 19200 19,200 bps baud rate (19.2 kbps). The
AML (connection from SDI/DCH card
to the IPE Module) rate must match
the baud rate of link 0 on the IPE
Module.
CLOK INT Internal clock (this prompt only
appears for ESDI)
IADR 3 Individual address for the data-link
level-HDLC protocol
RADR 1 Remote address for the data-link level
HDLC protocol
ÐcontinuedÐ