Meridian America Link/Customer Controlled Routing User Manual
Page 479
Chapter 14: Software installation, upgrade, and update procedures 461
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 8: Load the application software from tape (continued)
WARNING
Risk of system interruption
Do not attempt to press a keyboard key until the tape
active indicator light goes from on to off and stays off.
The tape drive can enter a nonoperational state if
operations are attempted before the drive is completely
ready.
8
When the tape indicator light is off, press [Return] to start the auto-
loading of the application software.
The system response is ÒInstalling Meridian Applications.Ó
9
You are prompted to press [Return] to continue. Press [Return].
A series of software install messages appears for approximately ten
minutes (Figure 230). If an error occurs, contact your Nortel support
personnel.
Figure 230
Software install messages 1
190 blocks
Preparing for installation. Please wait.
Preparing for installation successful.
10 blocks
30 blocks
7780 blocks
1100 blocks
110 blocks
1080 blocks
2080 blocks
430 blocks
11000 blocks
11320 blocks
.
(A series of messages appears on the screen.)
.
Installation Complete.
Host based X.25 is installed.
Setting file permissions and ownerships. Please wait.
Setting file permissions and ownerships completed.
06/01/94 19:56:44 Invoking maint