Meridian America Link/Customer Controlled Routing - Manual (Page 444)

426 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 5: Load the operating system tape on an Application Module
with an MVME147 card (continued)
29 You are prompted to indicate whether you wish to install online
problem descriptions. Nortel does not use these descriptions. Type n
and press [Return] to indicate no.
Figure 168
Verify installation prompt
---> Do you want to verify correct installation? (y, n, q) [y]:
30 You are prompted to verify correct installation. Press [Return] to
indicate yes.
Confirmation of your selection appears, along with a summary of the
installation information. The summary should look exactly as in
Figure 169, with the possible exception of the disk drive entry
(Ôm147fuj2614Õ).
Figure 169
Software installation summary
Selected to run mkcomply to verify correct installation.
Check the information below. If any part of the information is incorrect,
the previous questions will have to be answered again.
* Format and install the new bootloader on the MVME147,
controller #0, disk drive #00,
using the ddefs(1M) description Ôm147fuj2614Õ.
* Create a root file system using 1 Kbyte logical blocks
on slice 0 on the MVME147, controller #0, disk drive #00.
* Create a swap area in slice 1 on the
MVME147, controller #0, disk drive #00.
* Create a usr file system using 1 Kbyte logical blocks
on slice 2 on the MVME147, controller #0, disk drive #00.
* Install On-line Manual Pages Object Package (OLMP).
* Do Not Install On-line Problem Descriptions (Tars on Tape)
---> Is all of this information correct (y, n, q, ?):
31 If the summary information is correct, type y and press [Return]. If it
is not correct, type n, press [Return], and then enter the information
correctly when prompted.
When the information is correct and you reply y to the above prompt,
phases 3 and 4 of the installation begin.