Meridian America Link/Customer Controlled Routing - Manual (Page 192)

174 Chapter 9: Meridian Link/CCR interface cabling
553-3202-210 Standard October 1998
SDI Paddle Board cabling (Options 21Ð81 IPE Module only)
Port 3 of the NT1R03AA cable connects to the NT8D41 SDI Paddle Board
through an NT8D93A cable and, if additional length is needed, through an
NT1R03D extension cable. For pinout of the NT8D93A cable, refer to
ÒExternal I/O cable pinoutsÓ in this chapter.
As shown in Figures 45 and 46, the NT6D80 MSDL card connects to the
Meridian 1 I/O panel using an NTND27 SCSI II cable. From the Meridian 1
I/O panel, an NT7D58 cable connects to the IPE Module.
The NT7D58 cable has 25-pin male connectors at both ends. Table 55 lists
the pin assignments required for the cable.
Table 55
NT7D58 cable pinout
Meridian 1 Signal AM (J2)
1
2
3
4
5
6
7
8
15
17
20
24
Shield
TXD
RXD
RTS
CTS
DSR
LRTN
DCD
STC
SCR
DTR
SCTE
1
2
3
4
5
6
7
8
15
17
20
24
For more information about the NT8D41 SDI Paddle Board, refer to NT8D4
SDI Paddle Board (NTP 553-3001-181).