Meridian America Link/Customer Controlled Routing - Manual (Page 405)

Chapter 14: Software installation, upgrade, and update procedures 387
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
¥ Depending on the type of SBC card installed, perform one of the
following:
Ñ Procedure 5: Load the operating system tape on an Application
Module with an MVME147 card
Ñ Procedure 6: Load the operating system tape on an IPE Module or
an Application Module with an MVME167 card
¥ Perform Procedure 7: Reboot and go through setup.
¥ Perform Procedure 8: Load the application software from tape.
¥ Perform Procedure 9: Restore configuration files and data files from the
backup tape (if available).
Note: Input at the system console must be in lowercase letters, or
mixed case if necessary. If the system responds in uppercase prompts
preceded by a backslash (Ò\PASSWORD:Ó for example), log out. Reset
caps lock; enter Ctrl-d so that the ÒConsole login:Ó prompt appears.
!
CAUTION
Risk of potential data loss
In case of hard disk failure, your configuration files and
data files will be lost. Therefore, you should back up
these files as soon as you get your Meridian Link system
set up. To do this, perform Procedure 11: Back up
configuration files and data files.