Meridian America Link/Customer Controlled Routing - Manual (Page 403)

Chapter 14: Software installation, upgrade, and update procedures 385
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Section 12: To update CCR Release 3B to Release 3C
When you update CCR from Release 3B to Release 3C, the release or issue
of the BOS changes.
¥ Perform Procedure 2: Start the update process.
¥ Depending on the type of SBC card installed, perform one of the
following:
Ñ Procedure 5: Load the operating system tape on an Application
Module with an MVME147 card
Ñ Procedure 6: Load the operating system tape on an IPE Module or
an Application Module with an MVME167 card
¥ Perform Procedure 7: Reboot and go through setup.
¥ Perform Procedure 8: Load the application software from tape.
¥ Perform Procedure 9: Restore configuration files and data files from the
backup tape to customize your system.
¥ Perform Procedure 10: Verify the installation to confirm that the
installation is complete and correct.
¥ Perform Procedure 11: Back up configuration files and data files to
back up the customized new release.
Section 13: To update CCR from Release 3B to Co-residency
If you already have CCR Release 3B and want to update to co-residency,
you just enter a new keycode to activate CCR and Meridian Link.
To do this, perform Procedure 1: Application configuration and start-up.
Section 14: To update Co-residency from one issue to
another issue of the same release
When you update Co-residency from one issue of a release to another issue
of the same release (for example, from issue 6.2 to issue 6.4), one of the
following circumstances applies:
¥ The release or issue of the BOS changes
¥ The release or issue of the BOS does not change