Meridian America Link/Customer Controlled Routing - Manual (Page 450)

432 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 6: Load the operating system tape on an IPE Module or an
Application Module with an MVME167 card (continued)
Figure 175
Environment prompts (MVME167 card)
Bug or System environment [B/S] = S?
<cr>
Field Service Menu Enable [Y/N] = Y?
<cr>
Remote Start Method Switch [G/M/B/N] = B?
<cr>
Probe System for Supported I/O Controllers [Y/N] = Y?
<cr>
Negate VMEbus SYSFAIL* Always [Y/N] = N?
<cr>
Local SCSI Bus Reset on Debugger Start-up [Y/N] = Y?
<cr>
Local SCSI Bus Negotiations Type [A/S/N] = A?
<cr>
Note: The prompt ÒLocal SCSI Bus Negotiations TypeÓ may not
appear for all MVME167 cards.
Ignore CFGA Block on a Hard Disk Boot [Y/N] = Y?
<cr>
Auto Boot Enable [Y/N] = Y?
<cr>
Auto Boot at power-up only [Y/N] = N?
<cr>
Auto Boot Controller LUN = 00?
. <cr> (Type a period and press [Return].)
Note: If you changed or reentered any values in Figure 175, you will
see two additional prompts, to which you should respond as shown in
the following figure.
Figure 176
Additional prompts (MVME167 card)
Update Non-Volatile RAM (Y/N)?
y <cr>
Reset Local System (CPU) (Y/N)?
y <cr>
6 The system reboots automatically. Messages start to appear on the
console. Type h as soon as messages start appearing on the
console.
The start-up interrupt menu appears.