Meridian America Link/Customer Controlled Routing - Manual (Page 138)

120 Chapter 8: Hardware installation procedures
553-3202-210 Standard October 1998
Installing the IPE Module
The following procedure for installing the actual IPE Module is only one of
a series of procedures you should perform to install an IPE Module. The
series is shown in Table 11 in Chapter 5, ÒHardware installation overview.Ó
Before you start the following procedure, ensure that you have
¥ read Chapter 4, ÒMeridian Link/CCR hardwareÓ
¥ completed steps 1 through 3 in Table 11
If you have an older CE/PE or IPE shelf, you may need to reroute some
backplane cables before you install the IPE Module. If you have an older
CE/PE or IPE shelf, or if you are not sure whether you have an older shelf,
refer to ÒBackplane cable rerouting for Options 21Ð81 CE/PE and IPE
backplanesÓ in Chapter 9, ÒMeridian Link/CCR cabling interfaceÓ.
!
CAUTION
Risk of potential data loss
When installing the IPE Module, you do not need to
power down or stop the Meridian 1 system prior to
installation, however the IPE Module must be gracefully
powered down before removal or insertion.
1 Configure the IPE Module ports as DCE or DTE.
IPE Modules are shipped with the following default configuration. If
you are using the standard configuration described in the following
table, you should not need to change the settings. Figure 30 shows
the jumper settings for the default configuration.