Meridian America Link/Customer Controlled Routing - Manual (Page 144)

126 Chapter 8: Hardware installation procedures
553-3202-210 Standard October 1998
6 Plug the power harness into the connector on the MPDU (P3 if the
module is installed next to the MPDU, P4 if the module is on the
other side of the AEM).
Note: Make sure you connect all the cables securely.
7 Install the power supply and the disk/tape unit (refer to ÒInstalling the
power supply and disk/tape unit (Application Module)Ó in the next
section.
Note: Make sure you connect all the cables securely.