Meridian America Link/Customer Controlled Routing - Manual (Page 311)

293
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 12: Meridian 1 configuration for
Meridian Link/CCR
You should use this chapter in conjunction with Chapter 5, ÒHardware
installation overview,Ó which links hardware installation procedures in
easily understood tables (Tables 11 and 12).
This chapter shows how to use various software programs to configure the
Meridian 1 to support Meridian Link and CCR. See the X11 Input/
Output Guide (NTP 553-3001-400) for more information on these
programs.
Note: The information in this chapter is based on X11 Release 17 and
later software on Meridian 1. X81 International Phase 7 is supported,
but some prompts may look a little different.
Conventional notation
This chapter contains the following conventional notations:
¥ Default values are shown in parentheses and are defined using the
carriage return, noted as Ò<cr>.Ó
Example:
K 1Ð(7) Maximum number of outstanding frames
LTHR <cr>
¥ Input/output (I/O) information is shown in uppercase.
¥ Variables are shown in lowercase, or as a range of variables.