Meridian America Link/Customer Controlled Routing User Manual
Page 277
Chapter 9: Meridian Link/CCR interface cabling 259
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
10
At step 21 of Procedure 8, type the module address of the IPE
Module or Application Module and press [Return]. There are specific
requirements for the address. For more information, consult your
network administrator.
If you are activating support for an Ethernet LAN-based PC, continue
with steps 11-13.
11
When you have completed Procedure 8, ensure that the Ethernet
software has been installed on the LAN-based PC. The software
must be installed with VT220 emulation. For more information about
Ethernet software, refer to ÒEthernet LAN-based PCÓ in Chapter 1,
ÒMeridian Link/CCR co-residencyÓ.
12
At the PC, start a network session to the IPE Module or Application
Module using the host name and address from steps 9 and 10 in this
procedure. Refer to the documentation for the Ethernet software for
the procedure.
13
After the network session starts, you will receive a prompt to log in.
You can now log in as ccrusr in the usual way to perform CCR user
functions. Refer to the CCR User Guide for more information. Or you
can log in as maint in the usual way to issue Application Module or
link commands. Refer to the Application Module and Intelligent
Peripheral Equipment Module Diagnostic and Maintenance Guide
(NTP 553-3211-510) for more information.