Meridian America Link/Customer Controlled Routing - Manual (Page 330)

312 Chapter 12: Meridian 1 configuration for Meridian Link/CCR
553-3202-210 Standard October 1998
Enable ESDI or MSDL port (X11 Release 18 or later)
Commands in LD 48 require a port or link parameter, which is indicated in
the prompts as xx. Substitute the appropriate port or link number when
using the prompts listed below.
Table 110
LD 48ÑLink Diagnostic
Command Comment
ENL AML xx ACMS
ENL AML xx
Enable the AML on port xx (ESDI only)
Enable the AML on port xx (MSDL only)
The following commands may be used for diagnostic purposes:
STAT AML xx Show the status of the AML link.
ENL AML xx aaa Enable link xx or option aaa. Options include
(none) - no additional option
LYR2
- enable link layer 2
(MSDL must be enabled first)
FDL - forced download of AML software
(MSDL must be enabled and all AML
I/O ports disabled first)
AUTO - enable auto recovery of AML
(MSDL only)
LYR7 - enable application layer (7)
(AML must be established first)
MDL - enable MDL error reporting (MSDL only)
(AML must be enabled first)
MON - enable debug monitoring (MSDL only)
(AML must be enabled first)
ACMS - enable and start the AML on port xx
(ESDI only)
ENL MSGI/MSGO
xx Enable message input/output monitoring (xx=link)
DIS MSGI/MSGO
xx yy Disable message input/output monitoring (xx=link,
yy=priority)
Ñ continued С