Meridian America Link/Customer Controlled Routing - Manual (Page 520)

502 Chapter 15: Link configuration
553-3202-210 Standard October 1998
Procedure 17: Creating a configuration file (continued)
Figure 263
Change linkctl
mlusr>
change linkctl
Current Control File Image
0
HDLC /usr/mlusr/conf/hdlcmlnk.datafile
1 X25 /usr/mlusr/conf/x25hlnk.datafile
2 ASYNC /usr/mlusr/conf/vlink.datafile
Current Entry > 0 HDLC /usr/mlusr/conf/hdlcmlnk.datafile
Type :
"delete" to remove
"<ret>" to keep as is,
"<link number> <link type> <file name>" to change
Entry >
<cr>
Current Entry > 1 X25 /usr/mlusr/conf/x25hlnk.datafile
Type :
"delete" to remove
"<ret>" to keep as is,
"<link number> <link type> <file name>" to change
Entry >
1 X25 /usr/mlusr/conf/filename.datafile <cr>
Note: When typing the information, the entries HDLC, X25 and ASYNC
must be in uppercase and the pathname of the file must be in all
lowercase. The number of spaces between each parameter doesnÕt
matter. Do not type any control characters or escape sequences.
New Entry
Type :
"<ret>" end changes
"<link number> <link type> <file name>" add entry
Current Entry > 2 ASYNC /usr/mlusr/conf/vlink.datafile
Type :
"delete" to remove
"<ret>" to keep as is,
"<link number> <link type> <file name>" to change
Entry>
<cr>
New Control File Image:
0
HDLC /usr/mlusr/conf/hdlcmlnk.datafile
1 X25 /usr/mlusr/conf/filename.datafile
2 ASYNC /usr/mlusr/conf/vlink.datafile
Confirm? (yes or no):
5 Type yes and press [Return] to confirm that you wish to save your
changes to the link control file.
Any time the system is restarted, the link parameters will be read
from your configuration file.