Meridian America Link/Customer Controlled Routing User Manual
Page 442
424 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 5: Load the operating system tape on an Application Module
with an MVME147 card (continued)
26
You are prompted to enter the user file system slice number. Press
[Return] to use the default slice number (2).
Phase 2 of the BOS installation begins, and the slice table appears.
Figures 162Ð165 show disk-slicing tables for four different drive
types.
Figure 162
Disk-slicing table for 104-Mbyte disk drive
Phase 2. Configure Root And Usr File-Systems And Swap Area
Check the following slicing information for the root file systemÕs disk
drive; indicate below whether you wish to modify this information:
slice offset sl size fs size fsname vol-id info
0 648 40000 40000 root R3 1
1 40648 20000 0 1h8
2 60648 148484 148484 usr R3 1
3 0 0 0 1h8
4 0 0 0 1h8
5 0 0 0 1h8
6 0 0 0 1h8
7 0 209132 0 1h8
---> Modify any of these parameters? (y, n, ?, q): [n]
Figure 163
Disk-slicing table for 172-Mbyte disk drive
Phase 2. Configure Root And Usr File-Systems And Swap Area
Check the following slicing information for the root file systemÕs disk
drive; indicate below whether you wish to modify this information:
slice
offset
sl size
fs size
fsname
vol-id
K
0
648
60000
60000
root R3
1
1
60648
40000
0
1
2
100648
180000
180000
usr
R3
1
3
280648
54827
0
1
4
0
0
0
1
5
0
0
0
1
6
0
0
0
1
7
0
335475
0
1
---> Modify any of these parameters? (y, n, ?, q): [n]