Meridian America Link/Customer Controlled Routing - Manual (Page 523)

Chapter 16: Additional application configuration 505
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 18: Turn off auto-start
Meridian Link and CCR are configured by default to restart automatically
any time the system is powered down and up again (for example, in the
event of an unscheduled power outage). If you wish to start the CCR
application manually every time the IPE Module or Application Module is
rebooted, follow this procedure to turn off auto-start.
Note: This does not affect Meridian Link.
1 Log in as maint. The default password is maint.
2 At the Òmaint>Ó prompt, type bootconfig and press [Return].
The following prompt appears:
Figure 264
Bootconfig prompt
Application is configured to start when the system boots
Do you want to disable starting the application? [y,n]
3 Type y and press [Return] to turn off auto-start.
The ÒAuto start disabledÓ prompt confirms your change.
Figure 265
Auto-start disabled message
Auto start disabled
maint>