Meridian America Link/Customer Controlled Routing - Manual (Page 507)

Chapter 15: Link configuration 489
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 14: Changing Meridian Link (link 1) parameters
(Meridian Link only)
Meridian Link is shipped with a default configuration for the Host Link. To
make changes to the configuration file, use this procedure. Note that you
cannot change the values for some parameters. X.25 and LAPB parameters
are detailed in Table 142, TCP/IP parameters in Table 143.
!
CAUTION
Risk of potential data loss
Do not use the change link command without the
direction of Nortel support personnel or host computer
support personnel.
1 Log in as mlusr. The default password is mlusr.
2 At the Òmlusr>Ó prompt, type display link 1 and press [Return] to see
the current configuration for the link to the host computer.
The default link configuration is displayed, as shown under the
ÒDefault configurationÓ section earlier in this chapter.
3 Type change link 1 and press [Return] to begin making changes.
The first parameter appears, along with the current value.
4 Either type a new value for the parameter and press [Return] or just
press [Return] to leave the current value unchanged.
Refer to Table 142 or Table 143 for information on link parameters.
5 Continue changing parameters until the ÒConfirm (yes or no)Ó prompt
appears.
6 To confirm the changes, type yes and press [Return]. If you made a
mistake and wish to redo your changes, type no, press [Return], and
restart this procedure from step 3.
At this point, the changes you have made are saved in memory, but
not on disk (if the system is restarted, the changes are lost).
7 To save your changes, go to the appropriate procedure:
¥ Procedure 16: Replacing the default configuration file
¥ Procedure 17: Creating a configuration file