Meridian America Link/Customer Controlled Routing - Manual (Page 483)

Chapter 14: Software installation, upgrade, and update procedures 465
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 8: Load the application software from tape (continued)
Figure 240
List verification prompt
Saving default subnet mask:
The following applications are configured:
Meridian Link
Large CCR
The following packages are configured:
1
96
97
98
99
100
101
Ethernet NSE software is enabled.
Is this correct (y/n/q)?
The system lists the application or applications installed.
Note: Figure 240 only shows applications that have been selected;
they are actually enabled when the system reboots at the end of this
procedure.
To check that the correct application has, or applications have, been
installed, refer to the checklist (Table 17) you completed in the ÒIPE
Module and Application Module: Meridian Link/CCR softwareÓ
section in Chapter 6, ÒSite survey/installation checklist.Ó
19 The system prompts you to verify that the list is correct.
If the list is incorrect, type n and press [Return]. You are returned to
step 10. Rekey your Meridian ID and keycode. If the list of
applications is still incorrect, type q and press [Return]. The
message ÒSoftware not configuredÓ appears. Call your Nortel
support personnel for a new keycode.
If the list is correct, type y and press [Return].
If you did not purchase CCR or NSE, go to step 25.
If you did not purchase CCR but you have enabled NSE, go to step
21. For more information about Ethernet connections, refer to
ÒInstalling Ethernet LAN supportÓ in Chapter 9, ÒMeridian Link/CCR
interface cabling.У