Meridian America Link/Customer Controlled Routing - Manual (Page 410)

392 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 1: Application configuration and start-up (continued)
The system lists the application or applications installed.
Note: Figure 106 only shows applications that have been selected;
they are actually enabled when the system reboots at the end of this
procedure.
15 The system prompts you to verify that the list is correct.
To check that the correct application has, or applications have, been
activated, refer to the checklist (Table 17) you completed in the ÒIPE
Module and Application Module: Meridian Link/CCR softwareÓ
section in Chapter 6, ÒSite survey/installation checklist.Ó
If the list is incorrect, type n and press [Return]. You are returned to
step 6. Rekey your Meridian ID and keycode. If the list of
applications is still incorrect, type q and press [Return]. The
message ÒSoftware not configuredÓ appears. Call your Nortel
support personnel for a new keycode.
If the list is correct, type y and press [Return].
If you did not purchase CCR or NSE, go to step 21.
If you did not purchase CCR but you have enabled NSE, go to step
17. For more information about Ethernet connections, refer to
ÒInstalling Ethernet LAN supportÓ in Chapter 9, ÒMeridian Link/CCR
interface cabling.Ó
If you have purchased CCR, go to step 16.
Figure 107
CCR customer number prompt
Please enter the CCR customer number (0-99):
16 You are prompted to enter your CCR customer number (Figure 138).
Type the number and press [Return].
Note: A two-minute pause occurs at this point before the following
messages appear.