Meridian America Link/Customer Controlled Routing - Manual (Page 524)

506 Chapter 16: Additional application configuration
553-3202-210 Standard October 1998
Procedure 19: Change the Meridian 1 customer number
When you order CCR, you specify the customer number for the Meridian 1
system to which the CCR Module or IPE Module will be connected. CCR is
thus shipped with the customer number configured. If you want to change
the customer number (for example, if you connect the CCR Module or IPE
Module to a Meridian 1 system with a different customer number), use this
procedure.
1 At the ÒConsole Login:Ó prompt, type maint (if you are not already
logged in). The default password is maint.
2 At the Òmaint>Ó prompt, type applconfig and press [Return].
The following messages appear:
Figure 266
Customer number prompts
Enter a new value to change the following application parameter:
Enter Customer Number value as: 0-99
Enter a return for no change
Change ÔMSL-1 Customer NumberÕ from Ф1Х to:
3 The range of possible values (0Ð99) and the current value are
displayed. Type the new customer number and press [Return].
The following message appears.
Figure 267
Commit prompt
Do you want to commit this new value? [y,n]
4 Type y and press [Return] to confirm that you will use the new
customer number.