Meridian America Link/Customer Controlled Routing User Manual
Page 139
Chapter 8: Hardware installation procedures 121
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Table 28
Default DCE/DTE settings
Port
Setting
Use
1
DCE
Console
2
DCE
Modem
3
DTE
Conshare
4
DTE
Meridian Mail Link
5
DTE
AML
6
DCE
Terminal/printer (CCR)
X.25 Host Link (Meridian Link)
7
DCE
Terminal/printer
8
DCE
Terminal/printer
Refer to Figure 30 (Part 2) for a diagram of the correct jumper
settings. To change the configuration of a port after you have
installed an IPE Module, you must remove the IPE Module from the
Meridian 1 IPE Shelf or Option 11 cabinet. For more information on
DCE and DTE, refer to Chapter 11, ÒPeripheral device cabling
interface.Ó
!
CAUTION
Risk of data loss
Do not install the IPE Module if the IPE Module power
push button is in the On position.
2
Choose where you want to install the IPE Module. An Option 11
IPE Module occupies three consecutive slots in an Option 11
cabinet. An Options 21Ð81 IPE Module occupies four consecutive
slots on an IPE shelf. For more information, refer to Chapter 4,
ÒMeridian Link/CCR hardware.У