Meridian America Link/Customer Controlled Routing User Manual
Page 517
Chapter 15: Link configuration 499
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 16: Replacing the default configuration file
Meridian Link and CCR are shipped with a default link configuration. The
default configuration is shipped in the following file or files:
¥
AML (link 0): /usr/mlusr/conf/hdlcmlnk.datafile
¥
Host Link (link 1): /usr/mlusr/conf/x25hlnk.datafile (Meridian Link
only)
¥
MML (link 2): /usr/mlusr/conf/vlink.datafile (Meridian Link only)
If you have changed the default parameters in Procedure 13, 14, or 15, you
can do one of the following:
¥
Use this procedure to replace the default configuration with the
changed configuration.
¥
Use Procedure 17 to store the changed configuration in another file.
1
Use Procedure 13, 14, or 15 to change the configuration
parameters.
2
At the Òmlusr>Ó prompt, type save link x (where x is the link number)
and press [Return].
The following messages appear, in which ÒfilenameÓ represents the
name of the default configuration file.
Figure 261
Save link parameters
File "filename" already exists. OK to overwrite?
Confirm? (yes or no):
3
Type yes and press [Return] to confirm that you wish to overwrite
the file.
Your changes have now been saved on the hard disk.