Meridian America Link/Customer Controlled Routing User Manual
Page 469
Chapter 14: Software installation, upgrade, and update procedures 451
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 7: Reboot and go through setup (continued)
4
At the Т#У prompt, type portconfig -m and press [Return].
The following messages appear on your screen.
Figure 206
Portconfig warning
THIS WILL REMOVE EXISTING tty NODES IN Ô/devÕ AND
CREATE NEW ONES BASED ON THE DRIVERS CONFIGURED INTO THE
MOST RECENTLY BUILT KERNEL IN Ô/usr/src/uts/m68k/cfÕ AND THE CURRENT
HARDWARE CONFIGURATION. ARE YOU SURE THIS IS WHAT
YOU WANT TO DO?
(default = n) [y, n]:
5
If there is a tape in the drive, unlock the tape drive and remove the
tape.
6
Type y and press [Return].
The port configuration messages (shown in Figure 207) appear on
your screen.
Note: Figure 207 shows an entry about adding MVME167 controller
board entries. This is present even though the SBC card is an
MVME147 card or the module is an IPE Module, and is a result of the
software supporting the IPE Module and the MVME147 and MVME167
cards. Ignore the entry.