Meridian America Link/Customer Controlled Routing - Manual (Page 359)

Chapter 12: Meridian 1 configuration for Meridian Link/CCR 341
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Define non-ACD telephones as AST
To configure a DN as an AST telephone, make changes to telephone data in
LD 10 for single-line telephones or LD 11 for multi-line telephones.
Table 126
LD 10ÑDefine single-line telephones as AST
Prompt Response Comment
REQ NEW Add new telephones
TYPE 500 Single-line type of telephones
TN l s c u Terminal number
CDEN
DES
CUST 0Ð99 Customer number
DN xxxx Directory number of the telephone
AST YES Telephone is designated as
associated set
IAPG (0)Ð15* AML link status message group,
defined in LD 15. Since Group 0
sends no messages, the default
value is not normally used. Group 1
(all messages) or a customer-
designated group (2Ð15) would
normally be used here.
¥
¥
¥ Press [Return] until the REQ prompt
appears
REQ NEW, END Either define another single-line non-
ACD telephone as AST or exit the
overlay, saving changes
*Groups 10 through 15 are available only in X11 Release 17 or later
software.