Meridian America Link/Customer Controlled Routing - Manual (Page 305)

Chapter 11: Peripheral device cabling interface 287
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
4 Connect the modem directly to the IPE Module or Application
Module, as described in Chapter 9, ÒMeridian Link/CCR interface
cabling.Ó
If the modem installation is successful, the LED labelled ÒTRÓ on the
front panel of the modem lights up.
The following procedure explains how to configure the UDS 2440 modem
using a workstation.
1 Connect the modem to a workstation and apply power to both.
2 Enter each entry shown under the ÒInputÓ column in Table 104 and
press [Enter]. The system response to each entry should be ТOK.У
Table 104
UDS 2440 modem configuration (workstation)
Input System response
atz OK
at&f OK
ats0=1 OK
at&d3 OK
at&s1 OK
at&c1 OK
at&w OK
3 Power down the workstation and the modem.
4 Disconnect the modem from the workstation.
5 Connect the modem to the IPE Module using an NT1R03HF cable,
or to an Application Module using an NT7D99AA cable.
If the modem installation is successful, the LED labelled ÒTRÓ on the
front panel of the modem lights up.