Meridian America Link/Customer Controlled Routing - Manual (Page 343)

Chapter 12: Meridian 1 configuration for Meridian Link/CCR 325
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
In order for DNIS to be used on Incoming Digit Conversion trunks, the
trunk route must be configured to allow DNIS and IDC (Incoming Digit
Conversion).
Table 118
LD 16ÑTrunk route administration
Prompt Response Comment
REQ NEW, CHG Add or change data
TYPE RDB Route data block
¥
¥
¥ Press [Return] until the DNIS prompt
appears
DNIS YES Allow Directory Number Identification
System (DNIS) services
NDGT 1-(4)-31 Number of DNIS digits expected.
X11 Release 20 through 22: 1-(4)-7
X11 Release 23: 7, to program the feature
of a seven-digit DNIS
X11 Release 24: up to 31
¥
¥
¥ Press [Return] until the IDC prompt appears
IDC YES Allow Incoming Digit Conversion (IDC)
¥
¥
¥ Press [Return] until the REQ prompt
appears
REQ END Exit the overlay, saving changes to the route
data block
The translation tables define which DNIS numbers are routed to which
ACD DNs. Any range of numbers defined (indicated by Т*У) must be
contiguous. The beginning DNIS number and the last DNIS number in a
range must have the same number of digits.